Jaws Skirt

I saw this teal Jaws fabric at Joann’s and fell in love immediately. I bought three yards, intending to make myself a matching short and shirt set.

Jaws Skirt side

Clearly, I did not end up with shorts or a shirt. Initially, I used about two yards of the fabric to attempt to make a pair of shorts that looked like a skirt, similar to short culottes but with a gathered waist.

Jaws Shorts attempt

This is how the shorts looked around my second attempt. The looked fine on the mannequin, but when I put them on there was a weird triangular gap in the lower center front and back. Not only that, but when I sat down, they pulled in weird places and were uncomfortable to sit in.

Jaws Skirt front

I left the shorts alone for about a week, trying to figure out what to make from them. Eventually, I just cut the shorts into 6 large isosceles trapezoids. I sewed the sides of the trapezoids together, leaving one side open, and gathered the top into a waistband.

Jaws Skirt zipper close up

On the side that was still open, I sewed in an invisible zipper and two hooks and eyes. I then folded over the waistband and top stitched across the bottom with a silver glittery thread.

Jaws Skirt hem close up

I had already hemmed the shorts with the glittery silver fabric, so I just made sure to line up the bottoms of the pieces carefully so I wouldn’t have to sew another hem.

Jaws Skirt Front 2

After I finished the skirt, I did not have enough fabric left to make myself a matching shirt. There might be enough left to make my little sister a skirt, so there may be another Jaws Skirt post in the future!

I really like how this skirt turned out and have already worn it twice. I will definitely be wearing this a lot more!

Leave a Reply

Your email address will not be published. Required fields are marked *

Comment moderation is enabled. Your comment may take some time to appear.